Habitat - Indoor :: 55 gallon tank - Can hood shroud be replaced?

Turtle tank setups and other indoor configurations.

Post Posted: Sat Jun 25, 2016 4:36 pm   55 gallon tank - Can hood shroud be replaced?

My wife brought home a baby RES about a week ago, and a co-worker gave me his old 55 gallon tank but the top plastic part where the hood would sit is broken. See pictures. My question is can this be fixed or would it still work? Right now I ahve the turtle in a small insect cage half full with water so I'm rushing around trying to figure out all I need for a decent setup now that I have the tank.

Image

Image
berfles
 
Posts: 1
Joined: Jun 25, 2016

Post Posted: Sun Jun 26, 2016 4:28 pm   Re: 55 gallon tank - Can hood shroud be replaced?

I personally think that you'll need to buy a new tank, sorry for inconvenience! But i really don't think they could be replaced, i don't know, and anyways, only tanks..... they might not be in good condition! So i won't highly suggest that you replace it!
-anonymous <3 forever xox
elishawang
 
Posts: 64
Joined: Apr 29, 2016
Location: toronto
Gender: Female

Post Posted: Mon Jun 27, 2016 2:55 pm   Re: 55 gallon tank - Can hood shroud be replaced?

You should still be able to use it, though a thorough examination of the silicone is necessary or you will have a major leak. Also don't rest anything on it, like screens, fixtures or ATBAs. I think the sell replacement rims too, it should be an easy fix.
User avatar
steve
Site Admin
 
Posts: 29019
Joined: Apr 11, 2005
Location: New York, NY
Gender: Male

Post Posted: Mon Jun 27, 2016 3:15 pm   Re: 55 gallon tank - Can hood shroud be replaced?

Glass Cages carries a replacement for $15 if you want to go that route - it's the second from bottom on that list. I'd call them before ordering with a tape measure handy to make sure it will fit. Removing the old one should be easy with a razor blade or scraper, just make sure that all of the old silicone is cleaned off before installing the new one.

I'd give the rest of the aquarium a good inspection too, that center brace is there to keep the glass from bowing. Even if the glass isn't cracked anywhere, it may have caused stress on the seal if full of water while the brace was not in tact. In other words, after you replace the rim/brace and let it cure, fill it up and check for leaks!

Good Luck!
OtisDriftwood
 
Posts: 83
Joined: Jun 20, 2015
Gender: Male


Return to Habitat - Indoor

Who is online

Users browsing this forum: Bing [Bot] and 5 guests